Product Overview
Upgrade your classic vehicle from erratic mechanical breaker points to a solid-state electronic ignition system. This 1181-style conversion kit mounts entirely inside original Delco 8-cylinder distributors, offering stable timing, effortless cold starts, and maintenance-free operation while preserving the original engine bay look.
Key Advantages
- Maintenance-Free: Replaces mechanical contact points and condenser to eliminate point burn, pitting, and dwell adjustments.
- Solid-State Performance: Integrated Hall-effect sensor triggers accurate timing across all RPM ranges.
- Discreet Installation: Mounts inside the stock distributor housing under the original cap.
- Durable Module: Epoxy-encapsulated electronics protect against oil, dirt, and moisture exposure.
Specifications
| Part Style | 1181 Ignition Conversion |
|---|---|
| Distributor Type | Delco 8-Cylinder (Windowed Cap) |
| System Voltage | 12-Volt Negative Ground |
| Trigger Type | Hall-Effect Magnetic Sensor |
Vehicle Compatibility Matrix
Fits classic American V8 vehicles equipped with standard Delco 8-cylinder distributors:
- AMC V8: 1957–1959, 1963–1974 (Standard Ignition)
- Buick V8: 1957–1974 (Standard Ignition)
- Cadillac V8: 1956–1974 (Standard Ignition)
- Checker V8: 1964–1974
- Chevrolet V8: 1958–1974 (Single or Dual Points)
- Jeep V8: 1966–1974 (304 & 401 V8 Engines)
- Oldsmobile V8: 1956–1974 (Standard Ignition)
- Pontiac V8: 1957–1974 (Standard Ignition)
- Studebaker V8: 1960–1961 Lark & Regal / 1965–1966 V8 (Delco Distributors)
Package Contents (As Pictured)
- 1x Solid-State Pickup Sensor Module with Wiring Lead & Grommet
- 1x 8-Cylinder Magnetic Trigger Ring Adaptor (with threaded mounting studs)
- 1x Thermal Heat-Conduction Grease Sachet (for module thermal management)
- 1x Nylon Cable Tie & Wire Wrap
- 2x Insulated Ring Crimp Terminals (Red & Blue)
- 1x Hardware Fixing Kit (Nuts, Lock Washers, Flat Washers, Spacers & Screws)
Installation Note:
Apply a thin layer of the included heat conduction grease to the underside of the module baseplate during installation to ensure proper thermal dissipation. Connect Red wire to Ignition Feed/Coil Positive (+), Black wire to Coil Negative (-).
